Filter
Top Products
Viewing Full-Screen Compass
Toggle full-screen Compass by clicking the small Full Screen button in the upper left of any
Compass window.
Using Small Screen Scaling
If your computer has a low-resolution screen, Compass control pages may not fit on the screen
at its default size. To remedy this:
■
From User Interface Display and Control Options, select a User Interface Scale that
allows the Compass window to fit your screen.
When you reduce the user interface scale, the control handles on equalizers may become too
small to be useful. To counter this:
■
From User Interface Display and Control Options, select a Plotter Control Handle Scale
that will negate the reduction.
Show Meter Values on Meters
From User Interface Display and Control Options, enable Show Meter Values.
Retain Meter Clipping Indicator
By default the clipping indicator is on only for the duration of an over-signal event. To change
this:
■
From Clip Indicator Clear Mode, select a time-out option or select manual clear.
Connect Compass to Galileos On Start-up
To have Compass search the network for Galileos and connect to those Galileos and Virtual
Galileos which were active when Compass was last used, as well as listing all discovered
Galileos, set the following Startup Galileo Discovery and Connection Options:
■
Enable Find Available Galileos on startup.
■
Enable Relaunch and reconnect to previously connected Virtual Galileos on startup.
■
Enable Reconnect to previously connected Galileos on startup.
27
COMPASS USER GUIDE