Filter
Top Products
contain many snapshots. Snapshots capture the state of all controls, not just those that are on
a particular Galileo unit sub-page. Recalling a snapshot instantly sets the controls and system
settings to the saved values.
At the bottom of Galileo unit sub-pages is a set of snapshot and project control buttons. These
replicate important functionality found on the Project sub-page. Except where noted, the
following instructions assume use of this set of controls.
Snapshots
Creating a Snapshot
Using the controls at the bottom of any Galileo sub-page:
1.
Click Create. The Create New Snapshot window will be displayed.
2. Provide a name for the snapshot and, if
desired, a descriptive comment.
The new snapshot will be listed on the [Galileo
Unit] > Project page, in the Snapshot Library.
Recalling a Snapshot
1.
Select the [Galileo Unit] > Project page.
2.
From the Snapshot Library, select the desired snapshot.
3.
In the Snapshot Library control set, click Recall (there are two recall buttons; the other
is in the Boot Snapshot control set.)
All control values for the Galileo unit will be changed to match those that were captured in the
snapshot.
62
CHAPTER 3: USING COMPASS TOOLS