Subwoofer Filtering
Each output channel may be assigned a low or high pass filter. There are three filter choices
available:
Figure 3.3. Elliptical High PassFigure 3.2. 2
nd
Order High PassFigure 3.1. Low Pass
Using Low Pass Filtering
Low pass filtering is easily applied to a channel:
1.
Select the [Galileo Unit] > Output Processing > Channel Settings page.
2.
In the selection box beside the Freq control, select Low Pass.
3.
Using the Freq control or the High/Low Pass Response handle, set the knee frequency.
Using High Pass Filtering
1.
Select the [Galileo Unit] > Output Processing > Channel Settings page.
2.
In the selection box beside the Freq control, select:
■
2nd Order High Pass: provides a linear drop-off.
■
Elliptical High Pass: provides an exponential drop-off.
3.
Using the Freq control or the High/Low Pass Response handle, set the knee frequency.
Delay
Up to two seconds of delay may be applied to inputs and outputs.
58
CHAPTER 3: USING COMPASS TOOLS
