4-16 CHAPTER 4: NETWORK CONFIGURATION TASKS
An Example of Setting Up and Activating LANE Redundancy
The following is an example of a simple 2 CoreBuilder 7000 setup
demonstrating the LES/BUS and LECS redundancy.
Equipment (Hardware)
Software
3.1 or later version running on CoreBuilder 7000 and LS2700/7200
Hardware configuration: CoreBuilder 7000 A:
■ ATM address A*
■ IP addr/Gateway/Mask
■ LECS active
■ LES/BUS active
■ Active LECS address: Use Default (pointing to a*)
Hardware configuration: CoreBuilder 7000 B:
■ ATM address B*
■ IP addr/Gateway/Mask
■ LECS active
■ LES/BUS active
■ Active LECS address: Use Default (pointing to A*)
LS2700/7200 (A and B)
■ Bridge 0: Ports 1-6, ELAN name: admin, IP address/Gateway/Mask.
■ Bridge 1, ports 7-12, ELAN name: use ELAN ID elanxxx_0 from switch
B (NOTE: the LES/BUS for bridge 1 must be on switch B)
[CoreBuilder 7000 B]-----[CoreBuilder 7000 A]------[7200/2700 A]
[2700/7200 B]---------[NMS]
