Filter
Top Products
Configuring SNMP SmartAgents on Devices 2-3
(NMS). This allows the NMS to access these devices directly over the ATM
network instead of going across routers.
3 Configure the IP address, and default gateway of Bridge 0 in each of the
edge device units. See the device Installation and Setup Guide for the
devices you are using.
Configuring SNMP
SmartAgents and
Parameters
Community names set on the NMS must correspond with community
names set on the agent(s). Configure the SNMP generic parameters on
the ATM and VLAN Network Manager as follows:
1 Configure the default SNMP Community Setting on the Network
Management Platform according to Table 2-1. See the Network
Management Platform Administration Manual.
If default SNMP Communities are changed in the devices, you must enter
the new communities as well.
2 Verify the IP/SNMP connectivity using the IP Map.
All devices in the management subnet should appear on the IP Map of
the management platform. The IP connectivity is verified by the
appearance of the IP address. The SNMP connectivity is verified by the
appearance of the device icon. The process of establishing connectivity
should take about 5 minutes.
Table 2-1 Configuring SNMP Community Settings
Device
SNMP Community
Setting
CoreBuilder 7000
CoreBuilder 7X00
SuperStack II Switch 2700
Private
SuperStack II Switch
1000/3000/Desktop Switch
Security
SuperStack II Switch 2000 Private
CoreBuilder 2500/6000
CoreBuilder 5000 Switch
Module
Public
SuperStack II Switch 2000
TR
Security
NetBuilder II Public
CoreBuilder 4000 Public