Filter
Top Products
2-2 CHAPTER 2: CONFIGURING AND LAUNCHING THE ATM AND VLAN MANAGER
Click on the NMSetup icon in the ATMvLAN Toolbar. The NMSetup
Wizard Panel is displayed. See Figure 2-1.
Figure 2-1 NMSetup Step 1
For a detailed description of the NMSetup Tool see page 1-43.
Configuring SNMP
SmartAgents on
Devices
The NMS performs physical layer management using the SNMP. The NMS
polls agents for status, configuration and network traffic information.
The first step in initializing the network for management is to configure
the SNMP SmartAgents in the 3Com ATM and VLAN devices.
To configure the SNMP SmartAgents on Devices:
1 Determine the management IP subnet and IP addresses to be used for the
ATM devices and the Transcend ATM and VLAN Manager Station.
2 Configure the IP address and default gateway in each ATM switch unit.
See the device Installation and Setup Guide for the switches you are
using.
It is recommended that all the ATM and VLAN devices be configured as
members of the same subnet as the Network Management Station