Filter
Top Products
2-10 CHAPTER 2: CONFIGURING AND LAUNCHING THE ATM AND VLAN MANAGER
Starting Up the
ATM and VLAN
Manager
This section describes the start-up procedure for the ATM and VLAN
Management application for the HPOV/OVW platform:
Setting Up and
Customizing the ATM
and VLAN
Management
Application
Before you begin to use the ATM and VLAN Management application
there are several tasks that you should perform to setup and customize
the ATM and VLAN Management application. They are as follows:
1 Login to the UNIX workstation and start the OVW. See “Login to the
UNIX Workstation and Start the OVW” on page 2-10.
2 Discover devices via the OpenView IP Map. See “Discover devices via the
HP OpenView IP Map” on page 2-10.
3 Verify that you network is up and running. See “Verify that your network
is up and running.” on page 2-11.
4 Customize the VLAN colors and aliases. See “Customize the VLAN colors
and aliases.” on page 2-11.
5 Customize some of the other application configuration files using the
NMSetup Wizard. See “Customizing the Application Configuration Files”
on page 2-12.
6 Restart the ATM and VLAN Management application.
Login to the UNIX Workstation and Start the OVW
From the HPOV Root Window select ATMvLAN and then select Load
Transcend ATMvLAN Maps.
After a few seconds, icons representing the six ATM and VLAN
Management maps appear in the Root window. The ATMvLAN Toolbar
and the Virtual LANs and LAN Emulation windows appear.
Discover devices via the HP OpenView IP Map
Ping devices if they don’t appear in the IP map. Start the ATM and VLAN
Management application only after all the devices are discovered by
HPOV and are displayed in the IP map.
If you encounter problems discovering devices from the HPOV platform
database, or if you want to setup the application to ignore the platform