Filter
Top Products
2-8 CHAPTER 2: CONFIGURING AND LAUNCHING THE ATM AND VLAN MANAGER
3 The Network Management Station should be connected directly to the
switch running the primary LECS. This will ensure that the NMS always
has access to the LECS so that it can enable the backup LES when the
primary LES fails. See “Description of LES/BUS Redundancy” on page
4-10.
The CB7000 Fast Setup Tool
This CB700 Fast Setup icon opens a wizard that allows to configure the
CoreBuilder 7000.
To use the Fast Setup Tool.
Click on the FSetup icon in the ATMvLAN Toolbar. Step by step
procedures are displayed that allow you to configure the CB7000.
ATM Edge Device
Configuration
ATM edge devices such as Super Stack II Switch 2700, CoreBuilder 7200,
Switch 1000, CoreBuilder 5000 Switch Modules etc., provide the legacy
LAN-to- ATM integration. Some of these edge devices need to be
pre-configured to enable the LAN Emulation Clients within them.
Typically, this involves configuring the local bridge groups within the
devices and their corresponding LECs. Please refer to the appropriate
device configuration manuals for information on VLAN/ELAN
configuration of these devices.