Filter
Top Products
System Messages B-5
VLAN Move: SNMP SET error - [SNMP
status]- in device -[device IP address].
Device skipped.
error Wait for the ATMVLAN maps
to refresh. Check the VLAN
maps for results of the
previous operation and then
retry.
VLAN Move: No available LECs left in
device - [device IP address]. Device
skipped.
error Remove one or more VLANs
from the device. To remove,
use the VLAN Move operation
and move all the device
segments from the VLAN.
VLAN Move: Cannot find LEC in
device [device IP address]. Device
skipped.
error Reset CoreBuilder 2500/6000
or LANplex 2016/5000 and
retry the operation. If you do
not succeed, you may have a
problem with your device.
VLAN Move: Cannot create LEC - No
ATM card in device [device IP address].
Device skipped.
error Check the ATM card.
VLAN Move: Cannot move to VLAN -
[VLANID] in device - [device IP
address]. Might create two VLANs that
use the same ELAN. Device skipped.
error This move operation is
intended to the create a new
VLAN. Because of a mismatch
between the current and
config VLANs in the device,
creating the desired VLAN
might result in two VLANs
that use the same ELAN.
You may perform one of the
following actions:
1 Define the “admin” and
the “default” VLANs in the
VirtualLANs Configuration
window.
2 Reset device to synchronize
the current and config
VLANs.
3 Using the LMA, remove
non-existing VLANs from
the device.
4 Verify that the desired
VLAN is using its primary
ELAN.
Polling: SNMP GET Error - [SNMP
status] - in device - [device IP
Address]. Polling aborted.
error Restart polling.
Polling: SNMP GET timeout in device
[device IP address]. Retrying.
info None
VC Path Assistant: VC list is full in
device - [device IP address]. Operation
aborted.
error No space to define new PVC. Delete some VCs and try
again
Table B-1 System Messages
Message Type Meaning Action