Filter
Top Products
20-113
Cisco MDS 9000 Family Command Reference
78-16088-01, Cisco MDS SAN-OS Release 1.3
Chapter 20 Show Commands
show line
show line
To configure a virtual terminal line, use the show line command.
show line [com1 [user-input-string] | console [connected | user-input-string]]
Syntax Description
Defaults None.
Command Modes EXEC.
Command History This command was introduced in Cisco MDS SAN-OS Release 1.2(1).
Usage Guidelines None.
Examples The following example displays configured console settings.
switch## show line console
line Console:
Speed: 38400 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
The following example displays configured or default COM1 settings.
switch# show line com1
line Aux:
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Statistics: tx:17 rx:0 Register Bits:RTS|CTS|DTR|DSR|CD|RI
Related Commands
com1 Displays aux line configuration.
user-input-string Displays the user-input initial string.
console Displays console line configuration.
connected Displays the physical connection status.
Command Description
line console Configure primary terminal line.