Filter
Top Products
20-26
Cisco MDS 9000 Family Command Reference
78-16088-01, Cisco MDS SAN-OS Release 1.3
Chapter 20 Show Commands
show fc-tunnel
show fc-tunnel
To display configured Fibre Channel tunnel information, use the show fc-tunnel command.
show fc-tunnel [explicit-path [name] | tunnel-id-map]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History This command was introduced in Cisco MDS SAN-OS Release 1.2(1).
Usage Guidelines Multiple tunnel IDs can terminate at the same interface.
Examples The following example displays the FC tunnel status
switch# show fc-tunnel
fc-tunnel is enabled
The following example displays the FC tunnel egress mapping information.
switch# show fc-tunnel tunnel-id-map
tunnel id egress interface
150 fc3/1
100 fc3/1
The following example displays explicit mapping information of the FC tunnel.
switch# show fc-tunnel explicit-path
Explicit path name: Alternate1
10.20.1.2 loose
10.20.1.3 strict
Explicit path name: User2
10.20.50.1 strict
10.20.50.4 loose
explicit-path Displays all configured explicit paths.
name Specifies the explicit path name. Maximum length is 16 characters.
tunnel-id-map Displays the mapping information for the outgoing interface.