Filter
Top Products
20-33
Cisco MDS 9000 Family Command Reference
78-16088-01, Cisco MDS SAN-OS Release 1.3
Chapter 20 Show Commands
show fcdomain
show fcdomain
To display the Fibre Channel domain (fcdomain) information, use the show fcdomain command.
show fcdomain [address-allocation [cache] | allowed | domain-list | fcid persistent [unused] |
statistics [interface {fc slot/port | fcip fcip-id | iscsi slot/port}]] [vsan vsan-id]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History This command was introduced in Cisco MDS SAN-OS Release 1.0(2).
Usage Guidelines Issuing the show fcdomain with no arguments displays all VSANs. The VSANs should be active or you will
get an error.
Examples The following example displays the fcdomain information for VSAN 1.
switch# show fcdomain vsan 1
The local switch is a Subordinated Switch.
Local switch run time information:
State: Stable
Local switch WWN: 20:01:00:05:30:00:51:1f
Running fabric name: 10:00:00:60:69:22:32:91
Running priority: 128
Current domain ID: 0x64(100) ß verify domain id
address-allocation Displays statistics for the fcid allocation
cache The cache is used by the principle switch to reassign the FC IDs for a
device (disk or host) that exited and reentered the fabric. In the cache
content, VSAN refers to the VSAN that contains the device, WWN refers
to the device that owned the FC IDs, and mask refers to a single or entire
area of FC IDs.
allowed Displays a list of allowed domain IDs.
domain-list Displays list of domain ids granted by the principal sw
fcid persistent Displays persistent FCIDs (across reboot)
statistics interface Displays the statistics of fcdomain
fc slot/port Specifies a Fibre Channel interface.
fcip fcip-id Specifies an FCIP interface. The range is 1 to 255.
iscsi slot/port Specifies an iSCSI interface.
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093).