Filter
Top Products
44 HRB1684301-01
Chapter 3—Front panel display and meter setup PowerLogic™ PM5500 series user manual
1. Navigate to Maint > Setup.
2. Enter the setup password (default is “0”), then press OK.
3. Navigate to HMI > Pass.
4. Move the cursor to point to the parameter you want to modify, then press Edit.
5. Modify the parameter as required, then press OK.
6. Move the cursor to point to the next parameter you want to modify, press Edit,
make your changes, then press OK.
7. Press to exit. Press Yes to save your changes.
Lost password
Visit www.schneider-electric.com for support and assistance with lost passwords or
other technical problems with the meter.
Make sure you include your meter’s model, serial number and firmware version in your
email or have it readily available if calling Technical Support.
Setting the clock
The Clock setup screens allow you to set the meter’s date and time.
NOTE: You must always set or sync the meter time to UTC (GMT, Greenwich Mean
Time), not local time. Use the GMT Offset (h) setup parameter to display the correct
local time on the meter.
Password setup menu tree
Password setup parameters
Parameter Values Description
Setup 0000 - 9999
Sets the password for accessing the meter setup
screens (Maint > Setup).
Energy Resets 0000 - 9999
Sets the password for resetting the meter’s
accumulated energy values.
Demand Resets 0000 - 9999
Sets the password for resetting the meter’s
recorded peak demand values.
Min/Max Resets 0000 - 9999
Sets the password for resetting the meter’s
recorded minimum and maximum values.
Maint
Reset
Setup
Comm
Alarm
I/O
Meter
Displ
Region
Pass
HMI