Filter
Top Products
Reference Manual
00809-0100-4021, Rev DA
November 2004
A-15
Rosemount 3144P
Code Options
PlantWeb Functionality
A01 Regulatory control suite: PID with autotune, arithmetic, signal characterizer, input selector – FOUNDATION fieldbus only
D01 Diagnostics suite: SPM diagnostics, drift alert – FOUNDATION fieldbus only
Mounting Bracket
B4 Universal mounting bracket for 2-inch pipe and panel mounting—SST bracket and bolts
B5 Universal “L” mounting bracket for 2-inch pipe mounting—SST bracket and bolts
Meter
M5 LCD display
External Ground Lug
G1 External ground lug assembly (See “External Ground Screw Assembly” on page A-3.)
Integral Transient Protector
T1 Integral transient protector
Custom Software Configuration Request
C1
(2)
Factory enters date, descriptor, and message fields (CDS required with order)
50 Hz Line Voltage Filter Enabled
F5 50 Hz line voltage filter
NAMUR Compliant Alarm Failure
A1 Analog output levels compliant with NAMUR recommendation NE-43, June 1996. Alarm configuration high – HART only
CN Analog output levels compliant with NAMUR recommendation NE-43, June 1996. Alarm configuration low – HART only
Low Alarm
C8 Analog output levels compliant with Rosemount standard. Alarm configuration low – HART only
Transmitter-Sensor Matching
C2 Transmitter-Sensor Matching–trim to specific Rosemount RTD calibration schedule
C7 Trim to special non-standard sensor (special sensor–customer must provide sensor information)
Five Point Calibration Data
C4 5-point calibration (use option code Q4 to generate a calibration certificate)
Calibration Certification
Q4 Calibration certificate (3-point standard; use code C4 with Q4 option for a five point calibration certificate)
QP Calibration certificate and tamper evident seal
Dual-Input Custom Configuration (only with measurement type option code 2)
U1
(4)
Hot Backup
U2 Average temperature with Hot Backup and Sensor Drift Alert – warning mode
U3 Average temperature with Hot Backup and Sensor Drift Alert – alarm mode
U4 Two independent sensors
U5 Differential temperature
U6
(4)
Average temperature
U7
(4)
First good temperature
U8
(4)
Minimum temperature – FOUNDATION fieldbus only
U9
(4)
Maximum temperature – FOUNDATION fieldbus only
Special Certifications
QS Quality Documentation for Safety Instrumented Systems – HART only
Conduit Electrical Connector
GE
(5)
M12, 4-pin, Male Connector (eurofast
®
)
GM
(5)
A size Mini, 4-pin, Male Connector (minifast
®
)
Assembly
XA Sensor specified separately and assembled to transmitter
Typical Model Number: 3144P D1 A 1 E5 B4 M5
(1) When IS approval is ordered on a FOUNDATION fieldbus, both standard IS and FISCO IS approvals apply. The device label is marked appropriately.
(2) Consult factory for availability when ordering with F
OUNDATION fieldbus models.
(3) Consult factory for availability when ordering with HART or F
OUNDATION fieldbus models.
(4) Codes U1 and U6 for HART transmitters will not have drift alert enabled; option codes U1, U6, U7, U8, and U9 for Foundation fieldbus transmitters will have
drift alert enabled.
(5) Not available with certain hazardous location certifications. Contact an Emerson Process Management representative for details.