Doorphone Alert Extensions (#606)
Description
This System Programming procedure identifies up to 48 extensions that are to
signal when a doorphone button is pressed. When a person uses the
doorphone, it signals all alert extensions at the same time. If the alert extension
is a system phone, the call signals with a unique ding-dong sound to distinguish
it from other calls. Additionally, if you have two doorphones, they signal with
different tones so you can distinguish between them.
Related Features
■
■
You must use Doorphone Extensions (#604 and #605) to identify the
extensions to which doorphones are connected.
If Do Not Disturb is active at a doorphone alert extension, the person at the
doorphone hears signaling, but the alert extension is not signaled.
Considerations
You cannot bridge two doorphones together.
Valid Entries
1 = Not an Alert Extension ✔
2 = Doorphone 1 Alert Extension
3 = Doorphone 2 Alert Extension
4 = Doorphones 1 and 2 Alert Extension
Programming
To identify doorphone alert extensions:
1.
Press [
Feature
] [
0
] [
0
] [
System Program
] [
System Program
] [
#
] [
6
] [
0
] [
6
].
2.
Enter the first alert extension number (10–57). For example, to identify
extension 10, press [
1
] [
0
].
3.
To change the alert status, press [ Next Data ] until the appropriate value displays.
4.
To identify another alert extension, press [
Next Item
] or [
Prev Item
] until the
extension number shows on the display. Then repeat Step 3.
5.
Select another procedure or exit programming mode.
5-80
Doorphone Alert Extensions (#606)
