Filter
Top Products
Number of Lines (#104)
Description
This System Programming procedure determines in Key mode the number of
outside lines that are automatically assigned to all system extensions; in Hybrid
mode, it determines the number of lines assigned to the main pool. (This
number does not have to match the actual number of lines connected at the
control unit.) This feature should be used only for initial system setup.
Related Features
In Hybrid mode, do not use this procedure if you add lines to the system after
initial setup, because it changes Pool Line Assignment (#207), Pool
Extension Assignment (#314), Pool Access Restriction (#315), Automatic
Line Selection, and Line Ringing for existing pools back to factory settings.
Additionally, it changes Line Assignment (#301), Line Access Restriction
(#302), Automatic Line Selection, and Line Ringing for individual lines back to
factory settings. To change pool assignments without affecting other settings,
use Pool Line Assignment (#207) and Pool Extension Assignment (#314).
In Key mode, do not use this procedure if you add lines to the system after initial
setup, because it changes Line Assignment (#301), Line Access Restriction
(#302), Automatic Line Selection, and Line Ringing for existing lines back to
factory settings. To change line assignments without affecting other settings,
use
Line Assignment (#301).
Considerations
■
■
You can use this feature to tell the system how many lines are actually
connected at the control unit. For example, if some line jacks do not have
lines connected, use this procedure to indicate the number of jacks that
actually have lines connected; otherwise the line numbers associated with
empty jacks would be assigned to phones as though there were actually
lines connected.
You can use this procedure to limit the number of lines that are automatically
assigned to all extensions. For example, if there are ten lines connected at
the control unit, you can use this procedure to set the number of lines to
eight, so that only the first eight lines are assigned to all system extensions.
You can then use Line Assignment (#301) to assign lines 9 and 10 to
specific extensions.
Valid Entries
2 lines per 206 or 200 module, plus 4 lines per 400 module ✔
Programming
To assign lines to the system at initial system setup:
1.
Press [
Feature
] [
0
] [
0
] [
System Program
] [
System Program
] [
#
] [
1
] [
0
] [
4
].
2.
Dial two digits for the number of outside lines in the system (01–24) that you
want to assign to all extensions or to the main pool. For example, dialing
[
0
] [
6
] means that all extensions are assigned lines 1 through 6 or lines 1
through 6 are assigned to the main pool.
3.
Select another procedure or exit programming mode.
Number of Lines (#104)
5-143