Filter
Top Products
382
Pr.20, Pr.21, Pr.44, Pr.45, Pr. 147, Pr.791, Pr.792)........... 109
Setting procedure of IPM motor control (IPM)....................... 77
Setting the frequency by analog input
(voltage input)....................................................................... 189
Setting the frequency by analog input (voltage input) 189, 217
Setting the frequency by the operation panel (Pr. 79 = 3) 215
Setting the set frequency to operate (example
performing operation at 30Hz)........................................... 214
Simple magnetic flux vector control (Pr.80, Pr.90)............... 89
Slip compensation (Pr. 245 to Pr. 247) .................................. 90
Specification of main circuit terminal ...................................... 16
Speed display and speed setting
(Pr. 37, Pr. 144, Pr. 505)..................................................... 150
Speed smoothing control (Pr. 653, Pr. 654)........................184
Stall prevention operation (Pr. 22, Pr. 23, Pr. 48, Pr. 49, Pr.
66, Pr. 148, Pr. 149, Pr. 154, Pr. 156, Pr. 157)..................... 91
Start command source and speed command source during
communication operation
(Pr. 338, Pr. 339, Pr. 550, Pr. 551) ................................... 219
Start self-holding selection ..................................................... 133
Start signal selection (STF, STR, STOP signal, Pr. 250 ... 138
Starting frequency and start-time hold function
(Pr.13, Pr.571)......................................................................113
Stop selection (Pr. 250) .......................................................... 130
T
Terminal 4 input selection....................................................... 133
Terminal arrangement of the main circuit terminal, power
supply and the motor wiring ..................................................... 16
Terminal connection diagram................................................... 14
Terminal FM, AM calibration (Calibration parameter C0 (Pr.
900), C1 (Pr. 901))...................................................................159
U
Up to frequency........................................................................ 140
Use of CT and transducer ...................................................... 343
W
When connecting the control circuit and the main circuit
separately to the power supply................................................ 24
When using a heatsink protrusion attachment (FR-A7CN)361
Wiring and arrangement of RS-485 terminals..................... 226
Wiring and configuration of PU connector ........................... 224
Wiring instructions ..................................................................... 31
Z
Zero current detection............................................................. 140