Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Manager’s Guide
555-660-118
Issue 1
February 1998
Managing the System
Page 6-5Introduction to System Programming
6
The summary programming procedures describe steps for both the console and
the PC. You should use the appropriate procedure. The format is as follows:
The arrows separate each step. Table 6–1
shows the typefaces that indicate what
the step involves.
Table 6–1. Typefaces Used in Summary Programming Procedures
Introduction to System Programming 6
The system offers menu-driven software for performing the tasks described in this
chapter.
This section provides an overview of the types of programming, the programming
screens, and the appropriate
idle state
that the system must be in to perform
certain tasks.
Types of Programming 6
The following are the three types of programming available for the system:
■ System Programming. Allows you, as the system manager, to program
features that affect all or most system users. Perform system programming
using one of the following:
— System Programming Console. An MLX-20L telephone connected to
one of the first five jacks on the first MLX module in the control unit.
Console Procedure More→
→ →Dial calling group ext.
no.→
→Drop→Enter label→ → →
PC Procedure → → →Type calling group ext. no.→ →
+
→Type label→ → →
Typeface Meaning
More Select this option by pressing this imprinted button on the console.
Select this menu option using an unlabeled display button.
Dial ext. no. Enter this information.
Press this key on the PC.
Press this function key on the PC.
+ On the PC, while holding down the first key, press the second key.