Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Manager’s Guide
555-660-118
Issue 1
February 1998
Managing the System
Page 6-37Using Reports
6
Printing System Programming Reports 6
System programming reports can be printed out or viewed on the screen of a PC
with SPM or printed out on a serial printer connected to the SMDR jack on the
processor module in the control unit. You can print individual reports or use the
option to print the entire set of available reports, including all report sections
and options. See Appendix F of
System Programming
for samples of the print
reports.
For more information, see “Print Reports” in Chapter 4,
System Programming
.
NOTES:
1. If you select the
option, the reports take several minutes to print.
You may want to schedule use of the printer during off-peak hours.
2. If you select a report for which there is no information, the report
header still prints.
3. Print reports if you cannot back up your system programming
information.
4. If your system must handle more than 100 calls per hour, do not print
reports during regular hours.
5. If you are printing from the console, your printer must be connected to
the SMDR port. If you are programming on a PC with SPM, you have
the following choices:
■ Print reports on the SMDR printer (if available).
■ Print reports on the PC printer.
■ Save reports (on hard disk or floppy).
■ View reports (browse).
To print system programming reports, use one of the following procedures:
Console Procedures To print trunk information:
More
→ → →Select trunk type→
To print extension information:
More
→ →More→ →Dial ext.
no.
→ →
To print all other reports:
More
→ →Select report→