Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Manager’s Guide
555-660-118
Issue 1
February 1998
Managing the System
Page 6-80Revising Night Service with Group Assignment
6
the system manager to control off-hours operation on a line-by-line basis, and is
particularly useful when applied to personal lines. Night Service lines do not have
to be assigned to the Night Service group operator’s extension, nor are all lines
assigned to an operator position automatically assigned to that operator’s Night
Service group. If a line is assigned to a Night Service operator extension but not
assigned to the Night Service group, it is excluded from Night Service.
There is no limit to the number of lines and extensions that can be assigned to a
Night Service group. A line or extension can be assigned to more that one group.
The following types of lines can be assigned to a Night Service group in a Release
4.1 or later system:
■ Analog ground-start and loop-start lines/trunks as well as digital T1 voice
operation lines that emulate these types
■ ISDN digital PRI lines that are routed by line appearance
■ Digital NI-1 BRI lines
■ Automated incoming tie trunks
The following types of lines cannot be assigned to a Night Service group:
■ DID (Direct Inward Dial)
■ ISDN digital PRI lines that are routed by dial plan
■ Tie trunks directed to an extension (dial-in tie trunks)
■ Lines whose ports are programmed for Loudspeaker Paging, Alarm, or
Music On Hold
Valid Entries
Extension numbers
Line/trunk numbers
Task List: Revising Night Service with
Group Assignment 6
Obtain Form 9a, Night Service: Group Assignment.
If necessary, read “Night Service” in the
Feature Reference
for detailed
information about this feature.
Plan changes using the planning guidelines above; record the new values
on Form 9a.
Open the System Programming menu from the console or a PC with SPM.
Program the change(s), following the instructions for “Night Service Group
Assignment” in the “Labeling” section of
System Programming
, Chapter 3,
or the summary programming instructions below.
When you have finished, file Form 9a with the rest of the planning forms.