Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Manager’s Guide
555-660-118
Issue 1
February 1998
Managing the System
Page 6-93Removing a CTI Link
6
extension, use the main extension number (for example, extension 12 in a
2-digit numbering plan), not the adjunct extension number (for example,
extension 712 in a 2-digit plan).
Follow the procedure in the preceding topic, “Busying-Out and Restoring
the MLX Module,” to restore service on the module where the CTI link is
located.
When you have finished, file Form 2a with the rest of the planning forms.
To install the server-related hardware associated with the link, contact your
Lucent Technologies representative.
Programming Instructions 6
Removing a CTI Link 6
Use this procedure to remove the programming for a CTI (Computer Telephony
Integration) link from an MLX port on a 008 or 408 MLX module. This
hardware/software feature is available in Release 5.0 and later systems operating
in Hybrid/PBX mode.
NOTE:
This topic describes only the last steps in adding a CTI link to the system.
Additional LAN-related procedures are described in the
PassageWay
Telephony Services Network Manager’s Guide.
Task List: Removing a CTI Link 6
Obtain Form 2a, System Numbering: Extension Jacks.
Record the new values on Form 2a.
If necessary, read “Auxiliary Equipment” in
System Programming
, Chapter
4, for additional information.
Open the System Programming menu from the console or a PC with SPM.
Follow the procedure outlined in “Busying-Out and Restoring the MLX
Module” on page 6–91 to terminate service on the module where the CTI
link is located.
Console Procedure
→ → →Dial ext. no.→
→ →
PC Procedure → → →Type ext. no.→ → →