Filter
Top Products
MERLIN LEGEND Communications System Release 6.0
System Manager’s Guide
555-660-118
Issue 1
February 1998
Read This First
Page 1-7Environmental Requirements
1
After installation, you can help with the correct operation of the system by making
sure the following rules are observed:
■ The electrical outlet for the control unit must not be controlled by a switch.
Plugging the control unit into an outlet that can be turned on and off by a
switch invites accidental disconnection of the system.
■ The AC outlet must be properly grounded by using an AC receptacle for a
3-prong plug.
■ Do not install the control unit outdoors.
■ Do not place the control unit near extreme heat (furnaces, heaters, attics,
or direct sunlight).
■ Do not expose the control unit to devices that generate electrical
interference (such as arc welders, or the motors of air conditioners and
ventilators, compressors, and so on).
■ Each auxiliary power unit requires one outlet.
■ Do not expose the control unit to moisture, corrosive gases, dust,
chemicals, spray paint, or similar material.
■ Do not place anything that could block ventilation on top of or around the
carriers.
■ Do not install the control unit under any device that may drip fluid, such as
an air conditioner.
■ For maintenance purposes, the control unit should be mounted in an
accessible location. There should be sufficient room and lighting available
to remove the cover(s) and replace modules without moving furniture,
boxes, or other objects.
For more information, contact your Lucent Technologies representative.