Filter
Top Products
67
Operation Panel Display Selection
3
INVERTER FUNCTIONS
3.4 Operation Panel Display Selection
3.4.1 Monitor display (Pr. 52)
<Setting>
When "100" is set in Pr. 52, the monitor value changes depending on whether the
inverter is during stop or running.
You can choose the display of the operation panel "monitor/frequency setting
screen".
Parame
ter
Name
Factory
Setting
Setting
Range
52
Operation panel display
data selection
0 0, 1, 100
POINT
•
••
•You can also use the key to change the display. (Refer to page 42 for the
operation procedure.)
Signal Type Unit
Parameter Setting
Operation panel LED
Output frequency Hz 0/100
Output current A 1
0 100
During running/stop During stop During running
Output frequency Output frequency Set frequency Output frequency
REMARKS
•During an error, its definition appears.
•During reset, the values displayed are the same as during a stop.
•For selection of the parameter unit (FR-PU04) monitor display, refer to Pr. 992 "PU main
display screen data selection". (Page 94)
CAUTION
The unit displayed on the operation panel is only A and other units are not
displayed.
SET