Filter
Top Products
122
Parameter copy and parameter verification
(2) Parameter verification
appears... Why? Parameter read error. Perform operation from step 3 again.
appears... Why? Parameter write error. Perform operation from step 8 again.
and flicker alternately
Appears when parameters are copied between the converter of 55K or lower and 75K or higher.
1. Set "0" (initial value) in Pr. 0 Simple mode selection.
2. Set the following setting (initial value) in Pr. 989 Parameter copy alarm release.
3. Reset Pr. 50 to Pr. 57.
Whether the same parameter values are set in other converters or not can be checked.
REMARKS
If a model other than the FR-HC2 series is verified, "model error ( )" appears.
55K or lower 75K or higher
Pr. 989 Setting 10 100
1.Move the operation panel to the
converter to be verified.
2.Screen at power-ON
The monitor display appears.
3.Press to choose the parameter
setting mode.
5.Press to read the currently set
value.
" "(initial value) appears.
6.Turn to change it to the set value
" "(parameter copy verification mode).
7.Press to read the parameter setting
of the verified inverter to the operation panel.
• Hold down to verify.
8.It there is no difference, " " and " "
flicker to complete verification.
Flicker ··· Parameter verification complete!!
Display
The parameter
number read
previously appears.
Flickers for about 30s
Flickering
Operation
4.
Turn until (parameter copy)
appears.
• If different parameters exist, different
parameter numbers and flicker.
HC2.book 122 ページ ２０１２年１１月１９日 月曜日 午前１０時５２分