Filter
Top Products
67
3
PARAMETERS
Operation panel (FR-DU07-CNV)
3.1.2 Basic operation (factory setting)
Parameter setting
Faults history
Monitor
fault Input voltageat at the fault Bus voltage at the fault Energization time at the fault.
(After Energization time, it goes back to a fault display.)
Pressing the setting dial shows the fault history number.
Monitor mode (Input current monitor)
Parameter setting mode
Input voltage monitor
Bus voltage monitor
Display the present
setting
Value change
Parameter write is completed!!
Parameter and a setting value
flicker alternately.
Parameter clear All parameter
clear
Faults clear
Parameter copy
(Example)
[Operation for displaying faults history]
Past eight faults can be displayed.
(The latest fault is ended by ".".)
When no fault history exists, is displayed.
When a fault is displayed, the display shifts as follows by pressing : Input current at the
(Refer to page 134)
HC2.book 67 ページ ２０１２年１１月１９日 月曜日 午前１０時５２分