Filter
Top Products
66
Operation panel (FR-DU07-CNV)
3.1 Operation panel (FR-DU07-CNV)
3.1.1 Names and functions of the operation panel (FR-DU07-CNV)
REMARKS
FR-DU07-CNV cannot be used with the inverter. If FR-DU07-CNV is connected to an inverter, "Err." flickers.
(Setting dial: Mitsubishi inverter
dial)
Used to change the
frequency setting and
parameter values.
PU stop cancel
Cancels the (PS) display when
the converter is stopped by the
(PU stop).
Monitor (4-digit LED)
Shows the input current,
parameter number, etc.
Monitor indication
Lit to indicate monitoring mode.
P.CPY: Flickers at the completion of parameter
copy.
OFF at converter reset.
PWR : Lit at power ON
Power / regenerative drive indicator
DRIVE: Lit during power driving
REGEN: Lit during regenerative driving
(DRIVE or REGEN flickers when a stop is
made by turning SOF signal ON. (When Pr. 8
is set to "0 (initial setting)" .)
Stop operation
Used to stop the converter.
Fault can be reset when
protective function is activated
(fault).
Mode
switchover
Used to change
each setting
Unit indicator
· Hz: Lit to indicate frequency.
· A: Lit to indicate current.
· V: Lit to indicate voltage.
Used to set each setting.
If pressed during operation, monitor
changes as below;
Operation mode indicator
Input
current
Input
voltage
Bus
voltage
HC2.book 66 ページ ２０１２年１１月１９日 月曜日 午前１０時５２分