Filter
Top Products
16
Removal and installation of the converter (FR-HC2) front cover
2.1 Removal and installation of the converter (FR-HC2) front cover
Removal of the operation panel
1) Loosen the two fixed screws on the operation panel.
(These screws cannot be removed.)
2) Push the left and right hooks of the operation panel and pull
the operation panel toward you to remove.
When reinstalling the operation panel, insert it straight to reinstall securely and tighten the screws of the operation panel.
15K or lower
Removal
Reinstallation
1)Loosen the installation screws of the front
cover.
2)Pull the front cover toward you to remove by pushing an
installation hook using left fixed hooks as supports.
Installation hook
Front cover
Front cover
Front
cover
Front cover
R
E
G
E
N
PWR
P
.
C
P
Y
D
R
IV
E
M
O
N
R
EG
EN
P
W
R
P
.CPY
DRIVE
M
O
N
R
E
G
E
N
PWR
P
.
C
P
Y
D
R
I
V
E
MON
1) Insert the two fixed hooks on the left side
of the front cover into the sockets of the
inverter.
3) Tighten the installation
screws and fix the front
cover.
2)
Using the fixed hooks as supports,
securely press the front cover against
the inverter. (Although installation can
be done with the operation panel
mounted, make sure that a connector
is securely fixed.)
HC2.book 16 ページ ２０１２年１１月１９日 月曜日 午前１０時５２分