Filter
Top Products
23
2
INSTALLATION AND WIRING
Installation of peripheral devices
2.5 Installation of peripheral devices
2.5.1 Installation of reactor 1 and reactor 2
(1) Model name confirmation
Take caution as the appearances of the reactor 1 (FR-HCL21) and the reactor 2 (FR-HCL22) are very similar.
(2) Clearance
Because the reactor 1 (FR-HCL21) and the reactor 2 (FR-HCL22) generate heat, leave sufficient space around them.
(3) Installation place
Install the reactor 1 (FR-HCL21) and the reactor 2 (FR-HCL22) on nonflammable material. Direct installation on a
flammable material will cause a fire.
(4) Environment
Avoid places where the equipment is subjected to oil mist, flammable gases, fluff, dust, dirt, etc.
Install the equipment in a clean place or protect them from suspended substances.
MODEL
FR-HCL21-XXX
AC REACTOR
SERIAL XXXXX
MODEL
FR-HCL22-XXX
AC REACTOR
SERIAL XXXXX
Reactor 1(FR-HCL21)
Reactor 2(FR-HCL22)
Check "MODEL" on the rating plates of the reactor 1
(FR-HCL21) and the reactor 2 (FR-HCL22).
10cm or more
5cm or more
5cm or more
HC2.book 23 ページ ２０１２年１１月１９日 月曜日 午前１０時５２分