Filter
Top Products
19
2
INSTALLATION AND WIRING
Installation
2.3 Installation
Incorrect installation and connection may cause the equipment to operate improperly and its lifespan to be reduced
considerably. Please handle the unit properly in accordance with the information on each section as well as the precautions in
this manual.
2.3.1 Converter placement
(1) Installation of the converter
The converter consists of precision mechanical and electronic parts. Never install or handle it in any of the following
conditions as doing so could cause an operation fault or failure.
Installation on the enclosure
R
E
G
E
N
PW
R
P
.
C
P
Y
D
R
I
V
E
MO
N
Fix six points for 160K to 280K, and eight
points for 400K and 560K.
7.5K, 15K
30K or higher
NOTE
When encasing multiple converters, install
them in parallel as a cooling measure.
Install the converter vertically.
Refer to the clearance
on the next page.
Vertical
Direct sunlight
High temperature,
high humidity
Horizontal placement
Mounting to
combustible material
Oil mist, flammable
gas, corrosive gas,
fluff, dust, etc.
Vertical mounting
(When installing two or
more converters, install
them in parallel.)
Transportation by
holding the front cover
Vibration
(5.9m/s
2
or more at 10
to 55Hz (directions of X,
Y, Z axes))
2.9m/s
2
or more for the
160K or higher
HC2.book 19 ページ ２０１２年１１月１９日 月曜日 午前１０時５２分