Filter
Top Products
220
Error Log Functions Section 9-2
0101 Transmission failed because the local node is
not participating in the network.
FINS message communications command:
Bit 15: OFF
Bits 14 to 8: SNA
Bits 7 to 0: SA1
FINS message communications response:
Bit 15: ON
Bits 14 to 8: DNA
Bits 7 to 0: DA1
Explicit message communications command:
Bit 15: OFF
Bits 14 to 8: 0
Bit 7: ON
Bits 6 to 0: Node address of command source
Explicit message communications response:
Bit 15: ON
Bits 14 to 8: 0
Bit 7: ON
Bits 6 to 0: Node address of command source
No
0105 Transmission failed because of a node address
setting error.
0106 Transmission failed because of a node address
duplication error.
0107 Transmission failed because the other node is
not participating in the network.
0108 Transmission failed because there is no Unit
with the specified unit number.
0109 Transmission failed because the other node is
busy.
010B Transmission failed because of a CPU Unit
error. Frame discarded due to one of the follow-
ing:
• A cyclic service monitoring timeout occurred.
• A CPU Unit watchdog timer error occurred.
• Another CPU Unit error occurred.
010D Transmission failed because the destination
address is not registered in the routing table.
010E Transmission failed because the routing table
has not been registered.
010F Transmission failed because of a routing table
error.
0110 Transmission failed because of too many repeti-
tions.
0111 Transmission failed because the command
exceeded the max. command length.
0112 Transmission failed because of a header error.
0117 Packet discarded because the internal recep-
tion buffer is full.
0118 Illegal packet discarded.
0120 Unexpected routing error
0123 Packet discarded because the internal trans-
mission buffer is full.
0124 Routing failed because maximum frame length
was exceeded.
0125 Packet discarded because of response timeout.
021A Setting table logic error 00 Hex 03 Hex: Routing table
0A Hex: Master scan list
0B Hex: Slave scan list
0C Hex: Message moni-
toring timer list
Ye s
0211 Node address duplication (cause) 00 Hex Local node address No
0300 Packet discarded because of parameter error. Same as the code (such as 0101 Hex) in the dis-
carded FINS/explicit message packet.
No
0340 Bus Off detected 00 Hex 00 Hex No
0341 Network power supply error 00 Hex 00 Hex No
0342 Transmission timeout 00 Hex 00 Hex No
Error
code
(Hex)
Error Detail code Record
stored in
EEPROM
First byte Second byte