Filter
Top Products
109
Reference Manual
IP2048/RM, Rev AA
Appendix F: Configuring Using HART
February 2015
F.3.9 Distance offset (P060)
This defines the distance from the Sensor Reference Point (SRP) to the User Preferred Sensor
Reference Point (UPSRP).
Note
See Figure F-1 on page 106 for these points in a tank geometry illustration.
The read-only Distance / Tertiary Variable value (page 149) is calculated by subtracting the
distance offset from the live Distance value (page 153).
Note
The live Distance value is not affected by changes to the distance offset.
Field Communicator
To view or change the distance offset:
1. From the Home screen, select 2: Configure.
2. Select 2: Manual Setup.
3. Select 2: Level.
4. Select 2: Distance Offset P060.
5. If a change is required:
(a) Input the new distance offset, and press “ENTER” to save it.
(b) Press “SEND” to update the transmitter.
Note
When messages appear, take appropriate action if needed and press “OK”.
Mobrey MCU900 Series control unit
To view or change the distance offset:
1. From the Main Menu screen, select SETUP.
2. Select the transmitter (e.g. “Tx1:MSP400RH”).
3. Select DUTY.
4. Select Distance Offset.
5. Follow the on-screen instructions to edit and save the new setting.
(Press the Enter ( ) key if prompted to change mode to “off-line”).
6. Select “Quit” to exit to the previous menu.
Fast Keys
2, 2, 2, 2
Distance Offset P060
0.000 ft
0.000 ft
ESC
DEL ENTER
HELP
w
s
q
a
z
Lock
Shift
@ &
á ü
x
e
d
c
r
f
v
t
g
b
y
h
n
u
j
m
*
-
+
/
.
0
7
4
1
8
5
2
9
6
3
i
k
o
l
FN
(Field Communicator Screen)
Distance Offset
P060
0.0000ft
Esc=Quit =Edit
(Mobrey MCU901 Screen)