Filter
Top Products
34
Reference Manual
IP2048/RM, Rev AA
Section 4: Starting up
February 2015
4.2.9 Maximum flow entry
Screen display: Flo @ max
Factory default value: 1.000
This menu option is offered if the selected duty is Flow and requires entry of the maximum flow
capability of the chosen structure (not the maximum flow expected in the application).
Note
This menu option is in the programming menu. See Figure C-1 on page 76 for a map of
the menu structure and how to access the menu options.
To change the Flo@max value
1. If entering the menu system from the PV display, press the green button repeatedly
until the “Flo @ max” menu is indicated (see above note).
2. Press the blue button
to enter the “Flo @ max” menu and display the present
Flo@max value.
3. If the Flo@max value is correct, press the red button
to exit to the menu.
(The menu “Flo @ max” re-appears. To get to the next menu, press
4. Press the blue button to start the editing mode. The first digit flashes to indicate it
can now be edited.
5. Press the green button
repeatedly to edit the flashing digit.
6. Press the blue button
to move to the next digit. The digit flashes to indicate it can be
edited.
7. Repeat steps (5) and (6) until the last digit is flashing, and edited as required.
8. Press the blue button
to confirm the new value. (The flashing stops.)
9. If the new value is correct, press the red button
to save. The display changes to the
next menu option.
10. If the new value is incorrect, press the blue button
to exit to the menu.
11. The menu “Flo @ max” re-appears to re-start at step (2) or press
for the next menu.
Note
If the data entered allows the transmitter to calculate the maximum flow, the
4 and 20 mA points are set to 4 mA at zero flow and 20 mA at maximum flow.