Filter
Top Products
Chapter 4 Explanation of Functions
4 - 140
Coil No. Item R/W Setting
0035h LOG2 (logical operation result 2) R 1: ON, 0: OFF
0036h LOG3 (logical operation result 3) R 1: ON, 0: OFF
0037h LOG4 (logical operation result 4) R 1: ON, 0: OFF
0038h LOG5 (logical operation result 5) R 1: ON, 0: OFF
0039h LOG6 (logical operation result 6) R 1: ON, 0: OFF
003Ah WAC (capacitor life warning) R 1: ON, 0: OFF
003Bh WAF (cooling-fan speed drop) R 1: ON, 0: OFF
003Ch FR (starting contact signal) R 1: ON, 0: OFF
003Dh OHF (heat sink overheat warning) R 1: ON, 0: OFF
003Eh LOC (low-current indication signal) R 1: ON, 0: OFF
003Fh M01 (general output 1) R 1: ON, 0: OFF
0040h M02 (general output 2) R 1: ON, 0: OFF
0041h M03 (general output 3) R 1: ON, 0: OFF
0042h M04 (general output 4) R 1: ON, 0: OFF
0043h M05 (general output 5) R 1: ON, 0: OFF
0044h M06 (general output 6) R 1: ON, 0: OFF
0045h IRDY (inverter ready) R 1: ON, 0: OFF
0046h FWR (forward rotation) R 1: ON, 0: OFF
0047h RVR (reverse rotation) R 1: ON, 0: OFF
0048h MJA (major failure) R 1: ON, 0: OFF
0049h Data writing in progress R 1: Writing in progress, 0: Normal status
004Ah CRC error R 1: Error detected, 0: No error (*2)
004Bh Overrun R 1: Error detected, 0: No error (*2)
004Ch Framing error R 1: Error detected, 0: No error (*2)
004Dh Parity error R 1: Error detected, 0: No error (*2)
004Eh Sum check error R 1: Error detected, 0: No error (*2)
004Fh (reserved)
0050h WCO (window comparator O) R 1: ON, 0:FF
0051h WCO (window comparator OI) R 1: ON, 0:FF
0052h WCO (window comparator O2) R 1: ON, 0:FF
*1 Normally, this coil is turned on when the corresponding intelligent input terminal on the control circuit
terminal block is turned on or the coil itself is set to on. In this regard, the operation of the intelligent
input terminal has priority over the operation of the coil. If disconnection of the communication train
has disabled the master system from turning off the coil, turn the corresponding intelligent input
terminal on the control circuit block on and off. This operation turns off the coil.
*2 Communication error data is retained until an error reset command is input. (The data can be reset
during the inverter operation.)