Filter
Top Products
Reference Manual
00809-0100-4530, Rev BA
July 2009
F-5
Rosemount 5300 Series
Table F-3. Probe Type
STATS_TIMEOUTS 71 The total number of timed out A/D board message attempts
MAX_UPPER_PRODUCT_THICKNESS 72 This is the maximum thickness of the upper product that the
device is able to measure through. If the thickness of the
upper product is larger than this value, the device will not be
able to locate the interface echo
MEAS_STATUS 73
INTERFACE_STATUS 74
REMOTE_HOUSING 75
MEAS_VAPOR_DC 76 Measured Vapor Dielectric Constant
SPEC_CONFIG_TNZ 77 Configure Trim Near Zone
SPEC_CONFIG_PEP 78 Configure Probe End Projection
SPEC_CONFIG_TANK_MATERIAL 79 Configure Tank Material
SPEC_CONFIG_VC 80 Configure Vapor Compensation
VC_WARNING 81 Vapor Compensation Warning
PEP_STATUS 82 Probe End Projection Status
TANK_MATERIAL 83
SW_SUPPORT2 84 Defines what options are enabled in the device.
MOUNTING_TYPE 85
PIPE_DIAMETER 86
NOZZLE_HEIGHT 87
DEVICE_HW_CONFIG 88
DEVICE_STATUS 89
VOLUME_STATUS 90
MWM_WARNING 91
MEAS_WARNING 92
CONFIG_WARNING 93
VAPOR_COMP_STATUS 94 Vapor Compensation Status
Parameter Index Number Description
VALUE PROBE_TYPE
0 User defined
1 Rigid Twin
2 Flexible Twin
3 Coaxial
4 Rigid Single 0.3 in. (8 mm)
5 Flexible Single
10 Coaxial HTHP
11 Coaxial HP/C
12 Rigid Single HTHP/HP 0.3 in. (8 mm)
13 Flexible Single HTHP
20 Rigid Single PTFE
21 Flexible Single PTFE
30 Rigid Single HP/C 0.3 in. (8 mm)
31 Flexible Single HP
32 Flexible Single PA
33 Rigid Single 0.5 in. (13 mm)
40 Rigid Single HTHP 0.5 in. (13 mm)
41 Rigid Single HP/C 0.5 in. (13 mm)