Filter
Top Products
Reference Manual
00809-0100-4530, Rev BA
July 2009
H-3
Rosemount 5300 Series
VOL_VOLUME_OFFSET 46 Use this parameter to add a volume to each calculated volume
value. The volume can for instance correspond to a sump volume
that you wish to add to your calculation.
VOL_STRAP_TABLE_LENGTH 47 Number of points to use in the strapping table.
VOL_STRAP_LEVEL 48 Strap value level 1-20 points
VOL_STRAP_VOLUME 49 Strap value volume 1-20 points
ECHO_REG 50 Read Echo distance, amplitude and class from gauge. The Echo
Distance is the distance from the reference echo to the target echo
calculated by the radar from the plot and gauge configuration.
ECHO_WRITE 51 Echo Found/False Record
PEP_STATUS 52 Probe End Projection Status
PEP_PRODUCT_DC_LIMIT 53 Probe End Projection Dielectric Constant Limit
PROBE_END_PULSE_POLARITY 54
USED_MAX_VAPOR_DC 55
REF_REFLECTOR_TYPE 56 Reference Reflector Type
VAPOR_DC_FILTER_FACTOR 57 Vapor Dielectric Constant Filter Factor
SIGNAL_QUALITY 58
MIN_SIGNAL_QUALITY 59
MAX_SIGNAL_QUALITY 60
TIME_SINCE_LAST_RESET 61
SURFACE_NOISE_MARGIN 62 Surface/Noise Margin
MIN_SURFACE_NOISE_MARGIN 63 Minimum Surface/Noise Margin
MAX_SURFACE_NOISE_MARGIN 64 Maximum Surface/Noise Margin
VAPOR_COMP_STATUS 65 Vapor Compensation Status
DEVICE_COMMAND 66
DEVICE_COMMAND_STATUS 67
RADAR_INTERNAL_TEMPERATUR
E_RANGE
68
MAX_PRESSURE 69
MAX_TEMPERATURE 70
MAX_VAPOR_DC 71 Maximum Vapor Dielectric Constant
MEAS_STATUS 72 Measurement Status
CENTERING_DISC 73
PEP_TRIM_EMPTY_FAILURE 74 Probe End Projection - Trim Empty Failure
PEP_TRIM_FILL_FAILURE 75 Probe End Projection - Fill Failure
PEP_RAW_PRODUCT_DC_EST 76 Probe End Projection - Raw Product Dielectric Constant
Estimation
PEP_RAW_DC_EST_USED_DISTA
NCE
77
USE_PROBE_END_PROJECTION 78
USE_STATIC_PRODUCT_DC 79 Use Static Product Dielectric Constant
CALCULATE_SIGNAL_QUALITY_M
ETRICS
80
USE_VAPOR_COMPENSATION 81
SPEC_CONFIG_PEP 82 Configure Probe End Projection
SPEC_CONFIG_VC 83 Configure Vapor Compensation
Parameter
Index
Number
Description