Filter
Top Products
5-50
Note 1. The default setting depends upon the type of Inverter. The value for a 200-V-class 0.4 kW
Inverter will be displayed.
Note 2. These are values for a 200-V-class Inverter. Values for 400-V-class Inverter are double.
D Operator (o) Parameter Constants
Constant Name Regis- Setting Setting Default Chang
Control mode setting
ter No. unit range setting es dur-
ing op-
eration
V/f
control
V/f with
PG
Open
loop
vector
Flux
vector
o1-01 Monitor selection 0500 1 4 to 28 6 Yes Yes Yes Yes Yes
o1-02 Monitor selection after
power-on
0501 1 1 to 4 1 Yes Yes Yes Yes Yes
o1-03 Frequency reference
setting and display
units
0502 1 0 to 39,999 0 No Yes Yes Yes Yes
o1-04 V/f pattern setting
units
0503 1 0, 1 0 No No No No Yes
o1-05 Not used 0504 1 --- 0 --- --- --- --- ---
o2-01 Local/Remote Key 0505 1 0, 1 1 No Yes Yes Yes Yes
o2-02 Stop Key 0506 1 0, 1 1 No Yes Yes Yes Yes
o2-03 User constant initial
values
0507 1 0 to 2 0 No Yes Yes Yes Yes
o2-04 Inverter capacity
selection
0508 Hex 0 to FF (See
note.)
0 (See
note.)
No Yes Yes Yes Yes
o2-05 Frequency reference
setting method
0509 1 0, 1 0 No Yes Yes Yes Yes
o2-06 Operation selection
when Digital Operator
is disconnected
050A 1 0, 1 0 No Yes Yes Yes Yes
o2-07 Cumulative operation
time setting
050B 1 0 to 65,635 0 No Yes Yes Yes Yes
o2-08 Cumulative operation
time selection
050C 1 0, 1 0 No Yes Yes Yes Yes
o2-09 Factory use 050D 1 --- 0 --- --- --- --- ---
Note The default setting depends upon the type of Inverter. The value for a 200-V-class 0.4 kW Inverter
will be displayed.
CompoBus/D Communications Card Operations Chapter 5