Filter
Top Products
MERLIN LEGENDCommunications System Release 6.1
System Planning
555-661-112
Issue 1
August 1998
Lines/Trunks
Page 3-38Selecting Line/Trunk Options
3
9. If available, assign a test telephone number that is used for maintenance
by the service provider. For each 100D module with a PRI service type,
write the test telephone number (up to 12 digits) used for maintenance next
to the module number under the Test Telephone Numbers heading on
Form 3b (page 10).
NOTE:
The factory does not assign a test telephone number. You must
assign the same number as that furnished by the PRI service
provider. It must be different from the numbers assigned to other
channels associated with the same B-channel group.
10. Under the Timers and Counters heading, do
one
of the following:
■ To keep the factory setting, leave the Change to column blank.
■ To change the factory setting for any timer or counter, write the new
threshold on the appropriate line in the Change to column.
11. Under the Terminal Equipment Identifier (TEI) heading, do
one
of the
following:
■ To keep the factory-set TEI, check 0.
■ To change the factory-set TEI, write a value from 1 to 63 in the
space provided.
NOTE:NOTE:NOTE:
If the system includes DS1 connectivity, all local offerings of DS1
configurations must be reviewed by Lucent Technologies Sales and Design
Support Center (SDSC) personnel to ensure compatibility. For more
information, see Appendix D, “T1/PRI Review.” Also, information required
by the facilities vendor is discussed in Appendix E, DS1 Connectivity
Ordering.