Filter
Top Products
MERLIN LEGENDCommunications System Release 6.1
System Planning
555-661-112
Issue 1
August 1998
Control Unit Configuration
Page 2-10Recording System Operating Conditions
2
Automatic Maintenance Busy 2
The factory setting for Automatic Maintenance Busy is Disable, which means that
faulty lines/trunks are
not
automatically put in a maintenance-busy state.
In Key and Behind Switch modes, Automatic Maintenance Busy usually remains
disabled. If you plan to group lines/trunks into pools in Hybrid/PBX mode, enable
Automatic Maintenance Busy to provide optimal system performance.
For a detailed description of this feature (including considerations and feature
interactions), see the
Feature Reference
.
Planning Form Instructions 2
Under the Automatic Maintenance Busy heading in the System Operating
Conditions section of Form 1, page 2, do
one
of the following:
■ To keep the factory setting (no maintenance-busy state), check Disable.
■ To enable Automatic Maintenance Busy, check Enable.
Set System Date 2
The system date is the month, day, and year, shown on display telephones and
SMDR reports. For information on SMDR, see “System Features” in Chapter 4.
Error reports used by authorized technicians for maintenance also show the
system date and time.
These sections on the planning form remind you to set the system date when you
perform the initial programming for the system.
Planning Form Instructions 2
Check Yes under the Set System Date heading on Form 1 as a reminder to set
the current date.