Filter
Top Products
MERLIN LEGENDCommunications System Release 6.1
System Planning
555-661-112
Issue 1
August 1998
Features
Page 4-64System Features
4
3. Do
one
of the following:
■ If this is
not
a 1+7 table, skip to Step 4.
■ If this is a 1+7 table, do
one
of the following:
— If users do
not
need to dial a to reach numbers within their
own area code, check the not within area code box (factory
setting).
— If users need to dial a to reach numbers within their own
area code, check the within area code box.
4. Complete the Area Code/Exchanges section by doing
one
of the following:
■ If this is a 6-digit table, write the area code on the blank line next to
entry 001. Then write each exchange to be called in that area code.
Use the numbered lines, beginning with entry 002.
Up to 99 exchanges can be listed in any order. If you need to list
another area code with exchanges, prepare another 6-digit table.
■ If this is an Area Code, Exchange, or 1+7 table, write the area codes
or exchanges on the numbered lines, beginning with entry 001.
Up to 100 area codes or exchanges can be listed in any order, but
area codes and exchanges cannot be on the same table.
Example 1. If a business plans to use Table 1 to route calls to exchanges 333,
444, and 523 in area code 816, the upper section of the completed Form 3f will
look similar to Figure 4–2
.
Example 2. If the business plans to use Table 7 to route calls to the northeastern
(band 1) WATS lines/trunks as entries 001 through 015, the upper section of the
completed form will look similar to the one shown in Figure 4–3
.