Filter
Top Products
MERLIN LEGENDCommunications System Release 6.1
System Planning
555-661-112
Issue 1
August 1998
Features
Page 4-34Group-Assigned Features
4
c. Do
one
of the following:
■ To use a factory-set extension number, write the number in
the space provided (
770 for group 1, 771 for group 2, and
so on).
■ To change a factory-set extension number, write the new
number in the Renumber to space, and then on Form 2d,
System Renumbering: Special Renumbers, write the group
name in the Group ID Label column (up to 7 characters), and
the new number in the Renumber to column of the Group
Calling section of that form.
NOTE:NOTE:NOTE:
Before you complete the extension number and name entries in Step 4,
read Step 2 on page 4–37
of the instructions in the next section, “Calling
Group Options.”
4. In the Extensions section of Form 7d, write the extension number of each
member of the group in the Ext. No. column and the name of the person or
location in the Person or Location column (see Form 2a).
5. In the Trunks/Pools table of Form 7d, for each line/trunk that is to ring
directly into the calling group, write the line/trunk or pool number (see
Form 2c).
NOTES:
1. When a pool is assigned to a calling group, all lines/trunks in the
pool are assigned to the group. Individual trunks within the pool
cannot be assigned to a calling group.
2. If a pool contains any dial-in trunks (such as DID trunks), the
pool cannot be assigned to a calling group. Also, pools with
private network tandem trunks should not be assigned to calling
groups.
3. Pools may be assigned to only one calling group.
4. Lines/trunks assigned as the system Music on Hold or External
Page Port cannot be assigned to a calling group.
5. Before adding to a calling group, you must first remove
lines/trunks from the QCC.
6. If assigning a calling group as backup for a QCC, under the Position Busy
Backup heading in the Queued Call Console section of Form 6a, Optional
Operator Features, check yes and write the extension number of the
calling group.
7. To record information for another calling group, repeat this procedure
beginning with Step 3; use a blank Form 7d for each group.