Filter
Top Products
MERLIN LEGENDCommunications System Release 6.1
System Planning
555-661-112
Issue 1
August 1998
Features
Page 4-4Telephone and Extension Features
4
Queued Call Console (Hybrid/PBX Mode Only) 4
Use these instructions if the system includes one or more QCCs. Otherwise, skip
to the next section, “Pool Dial-Out Code Restriction (Hybrid/PBX Mode Only).”
Planning Form Instructions 4
1. Transfer the user information from Form 2a, System Numbering: Extension
Jacks to each copy of Form 5d, by filling in the Logical ID, Extension No.,
and Person or Location spaces. Use the Button Diagram on Form 5d, as a
guide for labeling the operator console buttons. You cannot change the
button assignments shown. However, if the QCC Voice Announce feature
is enabled, the Call 5 button becomes a VA (Voice Announce) button.
Refer to the “Operator Features” section later in this chapter.
2. Check the box under the Adjuncts heading that applies to the equipment at
the extension (see the floor plan).
3. Under Message Center Operator, check No if the QCC will not be a
message center, or Yes if it will be a message center.
NOTE:NOTE:NOTE:
If a calling group member is programmed as a QCC, the station is removed
from the calling group. If a Service Observing group member is
programmed as a QCC, the station is removed from the Service Observing
group. If a Service Observer station is programmed as a QCC, the station is
removed as a Service Observer.
Proceed to the next section, “Pool Dial-Out Code Restriction (Hybrid/PBX Mode
Only).”
Pool Dial-Out Code Restriction
(Hybrid/PBX Mode Only) 4
This section contains instructions to tailor the use of dial-out access codes by
restricting extensions from making calls on specific trunk pools (for example,
those consisting of special-purpose lines/trunks such as WATS or FX), or to
reserve trunk pools for data communications only.
Planning Form Instructions 4
Use Form 6i to identify those extensions that are restricted from using some
dial-out access codes. The factory setting is for
all
extensions to be restricted from
using
all
dial-out access codes. This form only identifies extensions that are to
remain restricted. Extensions that are not listed on this form must have their
restrictions removed through system administration. All extensions should be
restricted from dialing private network pools.