Lucent Technologies 6.1 Marine Radio User Manual


 
MERLIN LEGENDCommunications System Release 6.1
System Planning
555-661-112
Issue 1
August 1998
Control Unit Configuration
Page 2-8Recording System Operating Conditions
2
2. Do
one
of the following:
If you checked System Programming Console, proceed to Step 3.
If you checked PC with SPM Software, skip to the next section,
“System Mode.”
3. To change the factory-set system programming jack, write in the new
logical ID using the information from the Control Unit Diagram.
If you want the system programming jack to be different from that of system
operators, change the programming assignment to any one of extension jacks 2
through 5 on the first MLX module in the control unit (the lowest jack on the
module is extension jack 1). You fill in the extension number of the jack later.
System Mode 2
The mode of operation determines how outside lines/trunks are provided to users,
the types of operator consoles allowed, the features available, and how they work.
Each system is registered with the Federal Communications Commission (FCC)
to operate as a Private Branch Exchange (PBX), Hybrid, or Key system (factory
setting). However, you can program the system to operate in any of the three
modes: Hybrid/PBX, Key, or Behind Switch.
Planning Form Instructions 2
Under the System Mode heading in the System Operating Conditions section of
Form 1 (page 2), check
one
of the following:
If the system will operate in Key mode, check Key. (This is the factory
setting.) If need be, this mode can be changed to Hybrid/PBX mode at
another time.
If the system will operate in Hybrid/PBX mode, check Hybrid/PBX.
If the system will be connected behind a larger system or a Centrex
system, check Behind Switch and record the host’s dial codes for the
Transfer, Conference, and Drop features so users can access these
features on the larger system.
If you check Permanent Key, the switch in the back of the processor
module must be placed in the Permanent Key position. The switch cannot
be changed without changing the FCC registration of the system.