Filter
Top Products
MERLIN LEGENDCommunications System Release 6.1
System Planning
555-661-112
Issue 1
August 1998
Data Communications
Page 5-39Assigning Features to Data Stations
5
Planning Form Instructions 5
1. Using Form 3f, Automatic Route Selection Tables and Form 3g, Automatic
Route Selection Default and Special Numbers Table, review the values
assigned to the routes.
2. In the Optional Features section of Data Form 1a or 1b for each data
station to record your decisions about Facility Restriction Level, do one of
the following:
■ Check 3 to keep the factory setting.
■ To change the setting, write the value (0–6) for the ARS Facility
Restriction level you want to assign to each data station.
System Speed Dial Codes 5
To avoid giving the telephone number of a remote computer to modem pool users,
assign a System Speed Dial code to the telephone number. Users can dial this
3-digit code to place data calls to the remote computer.
For data calls, the telephone number programmed for a System Speed Dial code
must include the access code (the dial-out code or the ARS dial-out code) if
required.
To specify that the remote computer’s telephone number does not appear on call
reports, use the “System Speed Dial” instructions in Chapter 4 of this book.