Filter
Top Products
Appendix A - Advanced Display Module (ADM)
3A2098H 111
Fluid Plate x, Screen 1
This screen displays the current dispense control mode
used, the current pressure, and the current style being
dispensed. It also displays the target dispense volume,
the actual dispense volume, and the requested dis-
pense volume.
From this screen users can adjust the bead scale and
enter maintenance mode. Press and to
change the bead scale. Press to enter mainte-
nance mode.
The PCF system has two operating modes:
• Dispense mode – enables the module to begin dis-
pensing when it receives a command from the auto-
mation unit.
• Maintenance mode – enables the module to begin
dispensing when the user presses the manual dis-
pense button. Dispense parameters and duration
depend on the selected control.
Dispensing continues for as long as the manual dis-
pense button is pressed.
Current Dispense
Control Mode
Outlet Pres-
sure
Current Command
Value
Flow Rate
(systems with flow
meters)
Inlet Pressure
(non-heated systems)
Command Voltage
(Displays only when
Command Cable or Gate-
way is selected as the
Command Value Source;
see Fluid Plate Setup
Screens, page 105.)
Active Style
Progress Bar
Volumes
Active Dispense
Valves
Associated Swirl
Dispensers
Bead Scale
Quickly adjust pres-
sure/flowrate from this
screen