Filter
Top Products
Installation
22 3A2098H
Install Control Center
NOTE: This section applies to both the primary control
center and the expansion Swirl enclosures.
Mount
Ensure the following criteria are met before mounting
the PCF control center:
• Select a location for the control center that allows
adequate space for installation, service, and use of
the equipment.
• For best viewing, the ADM should be 60-64 in.
(152-163 cm) from the floor.
• Ensure there is sufficient clearance around the con-
trol unit to run cables to other components.
• Ensure there is safe and easy access to an appro-
priate electrical power source. The National Electric
Code requires 3 ft (0.91 m) of open space in front of
the control center.
• Ensure there is easy access to the power switch.
• Ensure the mounting surface can support the weight
of the control center and the cables attached to it.
Secure the control center with appropriate size bolts
through the 0.27 in. (7 mm) diameter holes in the mount-
ing tabs. See the following mounting dimensions.
Table 2: Control Center Assembly Measurement
A
10.50 in. (267 mm)
B
5.75 in. (146 mm)
C
22.00 in. (559 mm)
D
21.25 in. (540 mm)
F
IG
. 12: Control Center Dimensions
A
B
C
D