Filter
Top Products
Chapter 10 Adjustment
10–10
10-3-2 Vibration suppression measures
If vibration (machine resonance) occurs, it can be suppressed by lowering the speed loop gain (VGN1).
However, cutting precision and cycle time will be sacrificed. (Refer to "10-2-2 Speed loop gain".) Thus, try
to maintain the VGN1 as high as possible, and suppress the vibration using the vibration suppression
functions.
If the VGN1 is lowered and adjusted because vibration cannot be sufficiently suppressed with the
vibration suppression functions, adjust the entire gain (including the position loop gain) again.
<Examples of vibration occurrence>
• A fine vibration is felt when the machine is touched, or a groaning sound is heard.
• Vibration or noise occurs during rapid traverse.
POINT
Suppress the vibration using the vibration (machine resonance) suppression
functions, and maintain the speed loop gain (SV005: VGN1) as high as
possible.