Filter
Top Products
Chapter 8 Drive Section Connector and Cable Specifications
8–11
8-3 Cable clamp fitting
Install a grounding plate near the servo amplifier or scale I/F unit (MDS-B-HR), peel part of the
detector cable sheath to expose the shield coat, and press that section against the grounding plate
with a cable clamp fitting. If the cable is thin, clamp several together.
Clamp section drawing
The grounding plate D and cable clamp fittings A and B can be purchased from Mitsubishi.
Outline drawing of grounding plate (D) Outline drawing of cable clamp fitting
∗ Screw hole for wiring through cabinet to grounding plate
• Always wire the grounding wire from the grounding plate
to the cabinet's grounding plate.
• Two fittings A can be used.
L
Fitting A 70
Fitting B 45