Filter
Top Products
APPENDIX 7 CABLE MANUFACTURING DRAWINGS
Appendix 7.4 F321 Cable Manufacturing Drawing
I - 89
Appendix 7.4 F321 Cable Manufacturing Drawing
Application :
Control unit - manual pulse generator connection
(When connecting two manual pulse generators)
Option (Compatible connector set)
FCUA-CS000 (Note that only the
control unit connector is compatible)
List of parts used
F321
Note (3)
1
2
3
4
Control
unit side
Manual pulse
generator side
F321
Assembly drawing
No. Part name/type Maker Q'ty
1
Connector
10120-3000VE
Sumitomo 3M 1
2
Connector case
10320-52F0-008
Sumitomo 3M 1
3
Wire material
UL1061-2464
AWG22
× 6P
Note (1)
(1)
4
Crimp terminal
V1.25-3
J. S. T 8
Manual pulse
generator side
Maximum cable len
g
th: 30m
Control
unit side
4
14
6
1
1HA
1HB
+12V
GND
Case GND plate
3
13
16
11
2HA
2HB
+12V
GND
1HA
1HB
+12V
GND
2HA
2HB
+12V
GND
Connection diagram
Manufacturing precautions
(1) The wire material shall be a shielded, 6-pair stranded cable equivalent to UL1061-2464
Standards AWG22 (0.3mm
2
).
(2) The parts used shall be Mitsubishi recommended parts. Equivalent parts may be used providing
they are compatible with the specifications.
(3) Attach the nameplate (with protective cover stamped with the cable name) in the position
designated in the assembly drawing.
(4) Fold the wire material shield on the control unit side over the sheath, and wrap copper foil tape
over it. Connect to the connector case GND plate.
(5) Stamp the name of each signal on the crimp terminal side mark tube and install.
(6) In the catalog specifications, the part 1 connector uses AWG24 (0.2mm
2
) or less wire material,
but AWG22 (0.3mm
2
) can also be used.