Filter
Top Products
APPENDIX 7 CABLE MANUFACTURING DRAWINGS
Appendix 7.13 FCUA-R055 Cable Manufacturing Drawing
I - 98
Appendix 7.13 FCUA-R055 Cable Manufacturing Drawing
Application :
Control unit - synchronous feed encoder
connection (Right angle type)
Option (Compatible connector set)
FCUA-CS054
List of parts used
1
2
3
R055
4
5
Note (3)
Control unit side
Synchronous feed
encoder side
R055
A
ssembly drawing
No. Part name/type Maker Q'ty
1
Connector
10120-3000VE
Sumitomo 3M 1
2
Connector case
10320-52F0-008
Sumitomo 3M 1
3
Wire material
UL1061-2464
AWG22
× 12P
Note (1)
(1)
4
Right angle plug
MS3108B20-29S
ITT Cannon
1
5
Cable clamp
MS3057-12A
ITT Cannon 1
Maximum cable length: 30m
7
17
8
18
9
19
10
20
1
11
5
15
Case GND plate
B
P
C
R
A
N
H
K
Control unit side
Synchronous feed
encoder side
PC2
PC2*
PB2
PB2*
PA2
PA2*
+5V
+5V
GND
GND
GND
GND
Connection diagram
Manufacturing precautions
(1) The wire material shall be a shielded, 12-pair stranded cable equivalent to UL1061-2464
Standards AWG22 (0.3mm
2
).
(2) The parts used shall be Mitsubishi recommended parts. Equivalent parts may be used providing
they are compatible with the specifications.
(3) Attach the nameplate (with protective cover stamped with the cable name) in the position
designated in the assembly drawing.
(4) Fold the wire material shield on the control unit side over the sheath, and wrap copper foil tape
over it. Connect to the connector case GND plate.
(5) For the batch connection treatment and shield treatment wire, use AWG24 (0.2mm
2
) or
equivalent.
(6) In the catalog specifications, the part 1 connector uses AWG24 (0.2mm
2
) or less wire material,
but AWG22 (0.3mm
2
) can also be used.