Filter
Top Products
MERLIN LEGEND Communications System Release 5.0
System Manager’s Guide
555-650-118
Issue 1
June 1997
Managing the System
Page 6-12Introduction to System Programming
6
Table 6–4. Idle States
Idle State Description Procedures
System
Forced Idle
The entire system (every line and
every extension) is idle. No calls
can be made or received.
Multiline phone users hear a signal,
indicating that the phone cannot be
used; display phone users see the
message
Wait: System Busy;
single-line telephone users do not
hear a dial tone.
Select system mode (Lucent
Technologies only).
Identify system operator positions.
Renumber the system (Lucent
Technologies only).
Renumber modules (Lucent
Technologies only).
Identify extensions with voice signal
pairs for Voice Announce to Busy.
Restore backup file.
Extension
Forced Idle
No calls can be made or received
on that phone or data terminal.
Multiline telephone users hear a sig-
nal, indicating that the phone cannot
be used; display phone users see
the message
Wait: System Busy;
single-line telephone users do not
hear a dial tone.
Assign call restrictions.
Assign pool dial-out restrictions.
Copy extension assignments.
Assign lines, trunks, or pools.
Assign labels to a Personal Directory.
Use centralized telephone
programming.
Line or Trunk
Idle
The line or trunk is idle
only
at the
instant of programming.
Identify loudspeaker paging extension
jack.
Assign trunks to pools.
Assign incoming or outgoing DID or tie
trunk type (Lucent Technologies only).
Specify tie trunk direction (Lucent
Technologies only).
Specify tie trunk E&M signal (Lucent
Technologies only).
100D
Module Idle
Only the 100D module is idle. Specify (Lucent Technologies only):
Board type
Frame format
Board signaling format
Board suppression format
Board facility compensation